550Kg unbraked trailer refurbish kit
Avonride trailer suspension units
Unbraked
550kg capacity per pair (550kg total)
Galvanised units with durable long lasting rubber suspension
Extended stub axles
Complete with castellated nuts, washers and split pins
Mounting plates
2 x 6 hole mounting plates to suit suspension units
Complete with twelve M8 x 25mm hi tensile bolts, washers and nuts for attaching suspensionunits to mounting plates
Hubs
A pair of cast hubs to fit above suspension units
Taper rolling bearings
4 studs on 4" PCD
Complete with studs, nuts and dust caps
Grease
0.5kg tin of grease for use with hub bearings
Wheels
A pair of 500 x 10 inch trailer wheels with 4 ply high speed tyres to suit 4" PCD hubs
4 studs on a 4" PCD and load capacity of 308kg per wheel
65mm hole centre with grease nipple cut out
Rim supplied in silver
Note: (PCD = Distance between holes centres when measured diagonally)
Mudguards
A pair of mudguards suitable for the above 10" wheels
Mudguards measure 610mm (L) x 170mm (D) x 240mm (H)
Hitch
Fits 50mm square drawbar
Fits standard 50mm tow ball
Rated to 750kg
Pressed steel construction with a zinc plated finish for corrosion resistance
90mm mounting hole centres in top surface
R55 approved (d7.2, s75)
Fully E.U approved 94/20EC
Wear and correct attachment safety indicator
Supplied with high tensile M12 x 80mm bolts and nyloc nuts and washers
Lights and reflectors
Radex trailer lights 6 function right and left hand with quick fit connections 5800 series
Left and right rear 6 function lamp (Radex 5800)
Both with stop / tail / indicator / number plate / fog / reflex triangle
E approved
Bulbs included
Complete with mounting studs
Horizontal mounting
Each measures height 140mm, overall width 218mm, depth 60mm
Comes complete with 4 meter wiring harness. This consists of a 7 pin plug prewired into 2 x 4 meter long cables (a left and a right) both with quick fit plugs for easy attachment to lights, colour coded plugs match to corresponding coloured stickers on lights to signify left and right.
4 x rectangular reflectors, 2 amber for sides and 2 white for front
Each moulded with 2 fixing holes
For horizontal mounting
E approved
(W) 50mm x (L) 125mm x (D) 7mm
Safety chain
This secondary coupling chain is designed so that, in the event of seperation of the main coupling, the trailer will remain attached to the towing vehicle.
8mm chain
380mm in total
Connection to towing vehicle by placing ring over tow ball. Ring ID = 63mm (sized to fit over tow ball)
At the opposite end 12mm bolt hole for permanent fixture to trailer
Galvanised for weather protection
Skid plate
Designed to prevent the coupling hitting the ground in the event of coupling detachment and when the trailer is not in use
Skid is hot-dip galvanised for superior corrosion resistance
2 x 12.4mm mounting holes
Mounting hole centres 90mm
Height 90mm
Plug holder
Trailer plug holder for 7 pin trailer plugs
Bright zinc plated
Suitable for mounting on the top of trailer couplings
Angled to allow water to run out
Designed to store plug and prevent damage when not in use
26mm height
12.4mm mounting hole
